|Boards per Box||10|
|Square Meters / Box||2.48|
|Application||Suitable for bedrooms, living rooms, passages, hotel rooms, conference rooms, small offices - Do not fit in wet or outdoor areas.|
|Class||31 (Moderate Commercial)|
Remove Any carpet when doing the installation.
Make sure the floor is clean from dirt.
Imperfections in the floor should not exceed 2mm.
Laminate floor must acclimatize in the room for 48 Hours.
Underlay must overlap 200mm.
Start laying the first row of boards in a left-hand corner of the room with both tongue sides of the panel facing the wall.
insert the new panel to be laid at an angle from above into the connection system of the already laid element and lower it until it lies flat on the floor.
The last panel in the first row can be marked and cut to the required length. In the first row, make sure the long side is accurately placed, so as to be able to then connect the following rows without joints. Inserting a piece of the flooring as a stop/spacer between the wall and the flooring being installed in the first row, respectively in the area of the end joints, is recommended. After installing the first 2-3 rows, remove these positioning elements and correctly align the installed laminate flooring with the walls, observing the required gaps/placing the spacers Start installing the 2nd row with the remaining panel of the 1st row, if it is at least 200 mm long. For the following rows, the new row can be started with the remaining panel, while observing the minimum offset of the short ends.
Make sure that the short ends are staggered at least 200 mm. In case of products supplied with the bevel and/or with special pattern. ensure the offset is even according to the bevel and/or pattern. Place the tongue on the protruding lower lip of the first element of the first row Connect all the other panels for this row on their narrow sides as described above, until the entire row is installed. Then all narrow sides of the panels in this flow are facing each other and connected.
Slightly raise the first panel or panel section and connect its long edge with the first row. Continue to do so until you have connected the whole row with the previously laid row. Pay attention that the panels are not displaced along the short sides.
You can now lay panel after panel, row after row. In order to prepare the last row of panels for installation, take the panel and place it exactly on top of the row before last. By means of a residual panel (panel width) it is possible to transfer the wall structures to the panel within a pre-chosen distance.
Remove the boards that you started with.
Slide the floor forward against the perimeter spacers.
The smallest cutting width must not be smaller than 50mm.
Always use a transition strip between doors.
As is the case with all other floor coverings, you should protect your new laminate floor with a mat or dirt trap.
When moving heavy furniture, lift it, do not drag it across the floor.
Always attach felt pads to the feet of chair and table legs, and to the bottom of other pieces of furniture.
Wipe and damp or wet patches immediately.
Use only recommended Cleaning agents.
Waxing and/or polishing is not advisable.
It’s A Free Service.
Fast & Easy.
Skip the Queue and reserve your stock.
Collect from over 70 stores nationwide.
Orders are normally ready within 3 hours.
Should the product not be available at the selected store, one of our product experts will contact you and offer you a reasonable alternative.
We deliver all over South Africa and to most African countries.
We aim for next day deliveries in big SA metros.
We pack & unpack goods.
Goods are insured in transit.
How much does delivery cost?
The cost is dependant on the delivery address and weight of your order.
Add the products to your cart and checkout to calculate the delivery cost.
Should the product not be available in your region, we will offer you a reasonable alternative.
For Online delivery queries call 010 003 9987.
CTM supplies quality products to ensure your peace of mind.
You have 90 days to return any unopened, unused products in their original sellable condition.
We will gladly exchange or refund products provided that:
Please ensure you are satisfied with the product before installing as no claims will be accepted after installation.